PLEASE READ ALL INSTRUCTIONS - INCORRECT MOUNTING WILL VOID GUARANTEE STANDARD MOUNTING HARDWARE Included:  U-Bolt; (2) #5 Plates; (2) Hex Nuts Mounting Instructions: 1)  Lay sign on side so U-Bolt and Brochure Box are both facing upwards 2)  Drill hole 3-4" from top of sign (any drill bit larger than 1/4"). or Loosen top and bottom of sign panel, install U-Bolt between panel and frame - tighten bolts. 3)  Install (1) back plate on U-bolt.  This must be done in order for the lid to close automatically.   If the plate is not installed, the lid will bind on the sign frame and will not close. 4)  Install Brochure Box on studs of the U-bolt through holes on back of Brochure Box. 5)  Inside Brochure Box, attach (1) back plate and (2) hex nuts.  Tighten. STAKE MOUNTING HARDWARE Included:  (2) 1/2" Bolts; (2) Hex Nuts Mounting Instructions: 1)  Place (2) 1/2" bolts through Stake Mounting Plate. 2)  Place Brochure Box on bolts flush with the Stake Mounting Plate. 3)  Install (2) Hex Nuts inside Brochure Box.  Tighten. 4" X 4" WOOD OR ALUMINUM POST MOUNTING HARDWARE Included:  (1) Bracket; (1) 4" Bolt; (3) Hex Nuts; (2) 1/2" Bolts Mounting Instructions: 1)  Attach bracket to back of Brochure Box with (2) 1/2" bolts and (2) Hex Nuts.  Tighten. 2)  Fit bracket around the post, insert 4" bolt through holes in bracket, tighten with hex nut around post. 3" X 3" ALUMINUM POST MOUNTING HARDWARE Included:  (1) Bracket; (1) 3 1/2" Bolt; (3) Hex Nuts; (2) 1/2" Bolts Mounting Instructions: 1)  Attach bracket to back of Brochure Box with (2) 1/2" Bolts and (2) Hex Nuts.  Tighten. 2)  Fit bracket around the post, insert 3 1/2" bolt through holes in bracket, tighten with hex nut around post. ANGLE IRON MOUNTING HARDWARE Included:  (1) Bracket; (2) Hex Nuts; (2) 1/2" Bolts; (1) Thumb Screw Mounting Instructions: 1)  Attach Brochure Box to flat part of bracket with (2) 1/2" bolts and (2) hex nuts.  Tighten. 2)  Attach hook of brakete around angle of sign post, tighten with (1) thumb screw. ROUND ROD MOUNTING HARDWARE Included:  (1) Bracket; (2) Hex Nuts; (2) 1/2" Bolts; (1) Thumb Screw Mounting Instructions: 1)  Attach Brochure Box to flat part of bracket with (2) 1/2" bolts and (2) hex nuts.  Tighten. 2)  Fit the rod into the bracket and tighten with (1) thumb screw.